Helpful Articles Electric Guitar Sound: Setup and Effects for Beginners

Electric Guitar Sound: Setup and Effects for Beginners

Electric Guitar Sound: Setup and Effects for Beginners

An electric guitar’s sound is built from three parts: the guitar itself, the amplifier and the effects. Below is what to check on the guitar, how to set up the amp, which effects to try first and how to start a pedal collection.

The Guitar

  • Strings. Fresh strings sound brighter, so old ones get replaced from time to time.
  • String height and neck relief. If the strings sit too high, playing is hard work; too low, and they buzz. A technician sets this up.
  • Intonation. If a note drifts out of tune at the 12th fret, the string saddles on the bridge are moved; on most electric guitars, they adjust with a screwdriver or an Allen key.
  • Scale length is the length of the vibrating part of the string from the nut to the bridge. It is not adjusted, because it is fixed by the guitar’s design.

The Amplifier

An amp usually has volume, gain and an equalizer for bass, middle and treble. The more gain, the stronger the overdrive: early electric blues guitarists got it by cranking tube amps up loud. A good starting point is the equalizer knobs at the middle; from there, add or cut frequencies by ear. Sample settings:

  • clean sound: gain low, for chords and fingerpicking;
  • light overdrive: gain around halfway, for blues and rock;
  • heavy sound: gain higher, although classic metal keeps the overdrive moderate and simply plays the amp loud.

First Effects

  • Overdrive, distortion and fuzz raise the gain and give the sound a growl. Distortion is stronger than overdrive, and fuzz is the harshest of all; it began with faulty equipment.
  • Delay records the sound and plays it back after a pause, creating an echo.
  • Reverb imitates the way sound lingers in a room; spring reverb is loved by surf and dub reggae players.
  • Chorus makes it sound as if several guitars are playing slightly out of step, like voices in a choir.
  • A wah-wah is a pedal that makes the sound seem to “talk”; the first one was built in 1966 and went on sale in February 1967.

Pedals and Processors

A typical effects pedal sits on the floor and is switched with your foot; simple models have one footswitch and one to three knobs. Several pedals are connected one after another in a chain, and their order changes the sound. Another route is a digital processor that models amplifiers and effects in a single box: Line 6 released its first modeling amplifier in 1996, followed in 1998 by the desktop POD processor. To begin with, one overdrive pedal or one processor is enough; add more once you know what sound you are after.

Where to Start

First learn to sound good without effects: they highlight both the strengths and the mistakes in your playing. The first steps on the instrument are covered in Basics of Playing the Electric Guitar: First Steps for Beginners.

Our Electric Guitar Course

In our electric guitar course, students learn to read both sheet music and tabs, understand musical markings and work out guitar parts on their own, while also mastering chords and solos and learning rock songs. Lessons are open to students from age 8. A trial lesson costs $8.00: it is individual and lasts 45 minutes. More about the course is on the Electric Guitar page.

WhatsApp WhatsApp Facebook Messenger Messenger Telegram Telegram Viber Viber Instagram Instagram