Creating Your First Piece of Clothing: A Step-by-Step Guide
· Updated
A skirt with an elastic waist is a good choice for the first garment you sew yourself. It has no fastener and no darts: just a rectangle of fabric, one side seam, a casing with elastic, and a hem. Below is what you need and how to make it in six steps.
What You Need
- medium-weight cotton, which does not slip and is easy to stitch (choosing a fabric is covered in Best Fabrics for Sewing: Material Selection Tips);
- elastic 2–3 cm (about 1 inch) wide, preferably woven or knitted: these keep their width when stretched and stay springy after you stitch through them, while braided elastic soon loses its stretch once a needle pierces it;
- thread to match the fabric, pins, a safety pin, and tailor’s chalk;
- fabric scissors, a tape measure, and a ruler;
- a sewing machine and an iron.
Step 1. Take Your Measurements
You need three measurements: your waist, your hips at the widest point, and the skirt length from the waist to where you want the hem to fall.
Step 2. Cut a Rectangle
Make the rectangle one and a half to two times your hip measurement wide: the skirt has to slide over your hips, and the wider the rectangle, the fuller the gathers at the waist. For the height, take the skirt length and add the allowances: at the top, the elastic width plus 2 cm (3/4 inch) for the casing; at the bottom, 5 cm (2 inches) for the hem. If your fabric is not wide enough, cut two equal rectangles; the skirt will then have two side seams.
Step 3. Sew the Side Seam
Fold the rectangle in half with the right side inside, pin the short edges together, and stitch 1.5 cm (5/8 inch) from the edge, an allowance common in home sewing patterns. Finish the raw edges with a zigzag stitch and press the seam open.
Step 4. Make the Casing
A casing is a tunnel of fabric that holds the elastic. Fold the top edge 1 cm (3/8 inch) to the wrong side and press, then fold it again by the width of the elastic plus 1 cm. Stitch close to the lower edge of the fold, leaving a 3–4 cm (1½-inch) opening at the side seam.
Step 5. Insert the Elastic
Measure the elastic around your waist: it should feel snug but not tight, which usually means a few centimeters shorter than your waist measurement, and then add 2 cm for joining. Attach a safety pin to one end and work the elastic through the casing, holding the other end so it does not slip inside. Overlap the ends by 2 cm, stitch across them several times, and sew the opening closed. The elastic gathers the fabric into small folds; spread them out evenly.
Step 6. Hem and Fit
Try the skirt on and mark the length you want with chalk. Fold the bottom edge 1 cm to the wrong side and then another 4 cm, so the raw edge ends up inside the hem and cannot fray; press and stitch. Finally, press the finished skirt.
What Comes Next
After an elastic-waist skirt, you can move on to garments sewn from patterns, with darts, fasteners and sleeves. The basics for beginners, from tools and safety to how a pattern works and a first seam, are covered in Basics of Pattern Making and Sewing: First Steps for Beginners.
Sewing with a Teacher
In our sewing course, students learn the basic techniques, how to use a sewing machine and tools, and the properties of fabrics, and they make patterns and sew clothes and accessories. Lessons are open to students from age 7. A trial lesson costs $8: it is individual and lasts 45 minutes. More about the course is on the Sewing page.