Helpful Articles Basics of Modeling: Where to Start for a Beginner

Basics of Modeling: Where to Start for a Beginner

Basics of Modeling: Where to Start for a Beginner

Modeling is sculpture by addition: instead of cutting a shape out of a block, you build it from a soft material, adding and taking away as you go. Below is which materials suit a beginner, which tools you need, which techniques to start with and how to join pieces.

Materials

  • Plasticine never dries, so you can keep reworking a piece for as long as you like. It was created in 1897 by William Harbutt, an English art teacher, for his sculpture students. Plasticine is also used for the characters in stop-motion films.
  • Salt dough, a mix of flour, salt and water, is shaped by hand without special tools, dried in the oven and then varnished or painted with acrylics. Keep it away from pets: the salt is dangerous for them.
  • Clay is water-based. To turn a piece into ceramics, you fire it in a kiln at a high temperature.
  • Polymer clay is made from PVC and contains no actual clay. It hardens in an ordinary home oven at 129–135 °C (265–275 °F); if it overheats, it can give off a gas that irritates the eyes and nose, so bake it following the instructions and with an adult.
  • Plaster is a powder that sets and hardens when mixed with water, warming up as it does.
  • Wax and paper pulp can be modeled too, usually over a framework.

Tools

In our lessons you need modeling tools and cutters, which are used to cut, trim and smooth the material, and a flat table protected by a non-stick mat or board. At home, the same is enough to start, plus a damp cloth for your hands.

First Techniques

  • A ball, a coil, a flat pancake and a cone: almost any figure can be built from these shapes.
  • Pinching: press your thumbs into a ball of clay and pinch the walls as you turn it to get a cup or bowl. This is the simplest method and the one usually shown to children and beginners.
  • Coils: lay long rolls of clay in rings on top of each other and smooth them together to build a vessel of any shape without a potter’s wheel.

How to Join Pieces

Plasticine pieces are pressed together and the seam is smoothed over. Clay pieces are joined with slip, which is liquid clay. If a figure cannot stand on its own, for example because it has thin legs, you first make an armature, usually from aluminum wire fixed to a wooden base, and build the material up over it.

Your First Piece

Start with a small figure made of two or three simple shapes, such as an animal or a piece of fruit. How to go from a sketch to a finished sculpture is explained in How to Create Your First Sculpture: A Step-by-Step Guide.

Our Sculpture Course

In our sculpting lessons, students work with clay, plasticine and plaster: they learn to shape the material, join pieces and use sculpting tools, starting with simple figures and gradually moving on to compositions. Lessons are open to students from age 5. A trial lesson costs $8: it is individual and lasts 45 minutes. More about the course is on the Modeling and Sculpture page.

WhatsApp WhatsApp Facebook Messenger Messenger Telegram Telegram Viber Viber Instagram Instagram